7/23/2023 0 Comments Swapping cameras in cheetah3d![]() I am thinking is definitely a cable or camera issue. I tried swapping ports on the poe switch, nada. It was a pain to get that RJ45 end on at the porch but pretty sure I got it crimped down good. See if this issue follows the cable or the camera. I may wait a day or two and probbaly try to take that camera down and swap it with the location in the house and vice versa. I am in the south so 20F is brutal for me, lol. It was pretty solid 3k but sometimes even now it won't pull up. I was under the impression that the (Event) was for when something like motion occured so whatever you had set there would be what you are recording with? You know what they say about assuming though. What did you do to run the speed test to the camera w/ a laptop? I can access all of my network drops (including the cameras) right there directly the punch panel by the rest of my network equipment. What bit rate do you find you start having this issue tiger? ![]() The other end of the cable is punched down on a punch block, so there's that. I can watch the time on the camera though and see when it's skipping and anything over 3.5k for main steam normal and it does this or just won't display at all. I should also mention I am using variable bit rate, and not constant. I also noticed the freezing in playback with it over 4000. However, if I go any higher than 3-3.5k, it won't show up in the web interface. It's just sitting on the porch almost never triggering any motion. There isn't much action going on where the camera with the issue is with the exception of it's outside. ![]() The exact same model camera inside runs on that 12k bitrate w/ no problems (yet). I've done everything I can with the exception of redoing the end of the cable and/or as mla suggested putting a punch down w/ a patch cable or swapping the camera. I just installed the stuff yesterday so it isn't like it's been working for months and all of a sudden a problem, though. It was only this morning that the issue started to rear it's head. The most interesting thing is last night with a bit rate of over 12000, everything was humming along perfectly. Yes, I am seeing alot of what you mention. The only thing I can think of that I haven't tried is to swap ports on my POE switch but seeing as it's obviously recording the main stream upon motion, I am baffled. It was only 17F last night so I wouldn't think that would be an issue? The camera w/ no issue is inside. It is abnormally cold here right now and the camera in question is on the front porch. I still cannot get an image via the web browser on the LAN to come through when I select main stream. I went upstairs to the NVR and there are no errors and all is displaying there. I rebooted the camera via the direct login. I logged into the camera directly and can swap back and forth between sub and main stream and can clearly see the resolution changing between the two by focusing on the grass. It's there and obviously main stream as it's crystal clear (not lower resolution of sub stream). I went outside and triggered the motion and checked recording. The IVMS-4500 app displays both (because they are substream). The other camera connected displays on either main or sub stream via the browser across the LAN. When I swap to the sub stream in the web interface of the NVR, it displays. ![]() When I woke up this morning and hit the NVR on the LAN, I noticed one of the cameras would not display. I only have 2 of the 5 cameras up currently. I set some of the system up yesterday and things have been fine. They are without question Hikvision but the support comes from the company I bought them from. ![]()
0 Comments
Leave a Reply. |